Ferrofish B4000+

I bought the Ferrofish B4000+ B3 module for better organ sounding for duo on the base of Korg PA600, which lacks on organ drawbars and depends on samples only.

I connected both Ferrofish and PA600 over MIDI, both audio outs of B3 module to the Behringer mixer X-air XR18.
I do not believe that on old leslies could provide bass under 70Hz and High tones over 10kHz, so I put the Low and High cut, then I used small amount of Hall, Echo, Tubes and Pultec EQ on main audio out, headphones out I set totally dry, and voila, it comes perfect through the mix!
May be it is not perfect (Who is :)) but it is very very good!!!
I am learning the drawbar combinations, sound and percussion settings, rotor principle, and I am not missing anything any more...
Music has became more live, or with the melody with right hand or with accompainment with the left one.
Sound is pretty good, rotor whistles out, the drive groan...
I only had to make little cut for cca 2 dB from 1,5kHZ further in high frequencies...

Pros:
- very good sounding response on drawbars
- lot of possibilities for simulating the amps and B3
- great rotor simulation with lot of options
- i have to explore a little the percussions, I have to load last firmware with improvements for percussions
- I believe that the price is very affordable for both B3 module and Rotor simulator

Cons:
- at the beginning lot of combinations are not so easy to be managed
- sometimes strange behavoir at changing the parameters on main keyboard, so I have to learn a little (this item should stay in Pros area...)
- i can hear a little noise from the unit on the speakers

As you can see I am very very hapy...
May be not very best, but with little tweaking you can step out with pretty good sounding B3 simulation

Thanks to Thomann for great trade, fast delivery as always!

Regards,
Željko