Do treści strony

Treble Bleed Circuit

  • This treble bleed circuit consists of a 220K resistor in parallel with a 471pF capacitor which is soldered between the input and output of the volume potentiometer
  • This setup helps maintain the treble when the volume knob is turned down
  • Made in USA
  • Produkt dostępny od Sierpień 2025
  • Numer artykułu 621789
  • Jednostka sprzedaży 1 szt.
20,90 zł
Ceny z podatkiem VAT
Przedmiot dostępny w magazynie w ciągu około tygodnia
1

23 Oceny klientów

4.9 / 5

wykończenie

14 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
J
Great treble bleed, easy to install
Jonkarsy 25.09.2026
Gives the high end clarity when rolling down the volume. It can make the volume swell a bit rough at the begigngin but its easy to get used to it. Works great and the components are nicely soldered. As the capacitator and the resistor are already mounted makes the process of installing it in your guitar pretty straight forward.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
B
Sweeettt thingy!
BrilliantSolutions 17.09.2026
Whoever invented this, thanks! I love it! This goes so we'll with 1 meg volume on no tone knob mod. Opens so many possibilities at almost no cost.
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate de
Wystąpił błąd. Proszę spróbować później.
H
Gutes Upgrade für wenig Geld
HeMa 01.11.2025
Wer viel Fuzzpedale nutzt oder gerne mit dem Volumen der Gitarre arbeitet und hierbei das Problem hat, dass der Ton bei zurückdrehen des Volumepoti zu sehr abbricht und an Höhen und somit Substanz verliert, sollte hierüber nachdenken. Installation binnen weniger Minuten möglich. Wer davon nicht genug bekommen kann, sollte dann über den Kingtone Switch nachdenken ;)
wykończenie
2
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate it
Wystąpił błąd. Proszę spróbować później.
S
Prezzo esagerato.
Stormy54 21.01.2026
Prodotto ottimo, ma prezzo molto alto rispetto al valore dei componenti, preso per paragonarlo a quelli che mi sono fatto da solo, spendendo 10€ di componenti se ne comprano una quantità tale da farne almeno 200. Inutile dire che la qualità è assolutamente identica a quelli autoprodotti.
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie