H
Very sturdy and minimal tone loss
I got the Palmer PLI-05 to compare with the Radial SB-6 and Behringer HD400 for the purpose of removing extra noise from my pedalboard and amp setup. I am using a HX Effects in 4CM which is already notorious for adding some hiss but also ran into an issue of ground loop buzz in the FX loop of my amp (a modded Marshall). I wish the Palmer also had an option to change polarity of the other channel if needed and it would be bonus to be able to lift the ground on individual channels but nevertheless the isolator works fine for my use. Out of the three options it was the only one that did not show a significant drop in level and I could not really hear any tone loss to worry about. For my purposes the Palmer is the winner.
3
0
Zgłoś nadużycie
u
Good enough to be part of my gears
I got some troubles with a hand made crossover/preamp, I used this line isolator to reduce to the maximum the interferences and it works !!
Of course the ground noise couldn't be wiped out but everybody could say that with these gears the whole Sound system sounds better !
Of course the ground noise couldn't be wiped out but everybody could say that with these gears the whole Sound system sounds better !
2
0
Zgłoś nadużycie
B
Perfect 50/60 Hz hum remover
My Sequential Prophet REV2 and Korg Prologue 16 outputs were humming. These isolators solved the problem perfectly. No colouring of the sound. Don’t need a power supply. Rock solid and superb quality.
0
0
Zgłoś nadużycie