Do treści strony

Machine Head Set for Electric Bass

  • F-Style
  • Style: 4 Left
  • Bore: 18.5 mm
  • Gear ratio: 1:22
  • Surface: Nickel

Hole spacing on the base plate:

  • Narrow side: 20 mm
  • Wide side: 26 mm
  • From top to bottom: 34.4 mm

Dimensions of base plate:

  • Length: 45.3 mm
  • Width 1: 33.35 mm
  • Width 2: 27.2 mm
  • Produkt dostępny od Grudzień 2019
  • Numer artykułu 480068
  • Jednostka sprzedaży 1 szt.
  • Colour Nickel
189 zł
Ceny z podatkiem VAT
Dostępny w magazynie
1

39 Oceny klientów

4.8 / 5

wykończenie

31 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
M
Put them on an old neck. Great tuners!
Muziekschuur 10.12.2020
The good stuff! Nuff said. Thomann sells them. Get some.
Tune up and rock out.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
J
Good budget replacements
Jezzaboy 18.04.2020
Cheap tuners are part of the reason some basses are lower price. You cannot spend £300 and expect USA quality. Usually I would buy a set of Schaller tuners as they are my favourites but they are about £70-£80 delivered.

I recently picked up a cheap Squier and thought I would try the Kluson tuners to keep the cost down. They are quite good and keep the vintage look I was looking for. I still prefer my Schaller`s but for a budget bass, these do the trick fine.
wykończenie
3
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
M
Tuners ok, screws are very bad
MicDecorte 18.02.2026
The tuner mechanisms appear to be of good quality.

However, the screws are of very poor quality. If you want to buy these tuning mechanisms, you should also buy different screws. Three of the screw heads broke off when I used them. I had pre-drilled the holes. Two screws broke off before I could tighten them. One screw broke off while I was tightening it.

I am going to replace the screws because I don't trust that they will stay tight in the future.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
c
Tuners are OK but screws way to fragile
clowl 02.07.2025
I bought these tuners for an original Fender MiM neck. When mounting the tuners half the screws broke (head broke off) before it was fully tightened. Gave me a lot of extra work drilling out the metal and fitting new screws.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie