Dzięki naszym plikom cookie chcielibyśmy zaoferować najlepsze możliwe doświadczenia zakupowe wraz ze wszystkim, co się z tym wiąże. Obejmuje to na przykład odpowiednie oferty, spersonalizowane reklamy i zapamiętywanie preferencji. Jeśli Ci to odpowiada, po prostu udziel zgody na używanie plików cookie do preferencji, statystyk i marketingu, klikając „W porządku!” (pokaż wszystko) Zgodę można wycofać w dowolnym momencie za pośrednictwem ustawień plików cookie (here)
Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.
Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".
Got this to replace the previous actuator which was of a really hard rubber( this actuator was original from Roland).
After a few months of use this actuator is very unresponsive
and the rubber it is made of it's probably the same as the one I had,which came from a bad batch from Roland's supplier.
It is an improvement over the one I previously had but I wouldn't recommend it,especially due to the high price for such a product.
It's back! anyone using the FD 8V high hat controller knows they fade over time, the control actuator becomes hard and inflexible you find you have to put your full body weight on it to close the hats, this little piece of rubber solves that! it takes minutes to fit, your pedal feels and acts like new. Only down side is its costly for a bit of rubber, but definitely cheaper than a new pedal.
Must change Actuator part as became plastic hard after few years
Tom.K. 21.11.2025
Spare part you need to replace on foot pedal - mine is for FD8 from TD-11 set, foot hi-hat pedal controler. Easy to replace. If you have hardnes in your foot pedal this is a must replacement. This part should cost less as at the end it is design flaw because this rubber became hard and it have life span of few years after that this rubber became like plastic hard and pedal is usless.