Do treści strony

6.3 mm Mono Jack Angle Connector

  • Maximum cable diameter: 7.14 mm
  • Metal connector
  • High quality
  • Produkt dostępny od Maj 2000
  • Numer artykułu 128508
  • Jednostka sprzedaży 1 szt.
  • Installation No
  • Mono/Stereo Mono
  • Angled Yes
  • Type TS (mono/unsym.)
  • Plug Jack 6,3 mm TS male angled
4,22 zł
Ceny z podatkiem VAT
Rabat ilościowy
Cena jednostkowa Oszczędzasz Ilość
4,22 zł 1
4,05 zł 4,0% 10
3,75 zł 11,1% 50
Dostępny w magazynie
1

1030 Oceny klientów

4.5 / 5

wykończenie

419 Opinie

m
The cheapest, decent angled plug
mkgt 07.01.2024
It's built well, easy to solder onto, I think I've bought about 200 over the last couple years to be used mainly in pedalboards, not one has failed on me yet.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

D
DecuPoznań 25.04.2025
Solidne w dobrej cenie. Polecam
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

H
Good plug
Horbi 19.08.2025
Well made plug easy to solder. Good Quality.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
W
Thomann SK140 Jack mono Angled
WD555 30.04.2017
Thomann SK140 Jack mono Angled
I have used these Thomann mono angled jacks many times before and they are in my opinion the best value in angled jacks.
Much cheaper than the big brand name jacks and really very good quailty for the price paid.
The metal outer casing is robust and I have never had any damage to them.
The outer casing screws over the inner part and the threads are well cut without any rough edges - the two parts do unscrew quite easily and I have taken to adding a little locktite thread locker o these threads to stop them from unscrewing in use but obviously only after I have tested the final cable is working !!!
Inside the outer cover is a thin plastic sleeve which slides over the connection to prevent the inner core terminal shorting to the ground cover.
The terminals are easily soldered and the outer clamp is easy to form with a crimping tool or carefully with needle nose pliers.
I add 75mm of heatshrink tubing to cover the side joint, again only after the vale has been tested, this protects the joints and also adds some protection in the form of relieving cable strain where the cable enters the housing, this technique is used on the "pro snake" cables which I believe also use the same angled mono jack plugs.
If you are using these jacks to make patch cables for a pedal board and want the angled jacks to be as close as possible (together, back to back ) then two jacks will require approximately 32mm space between pedals.
3
0
Zgłoś nadużycie

Zgłoś nadużycie